Toyota Tercel — Answers.com

23 Мар 2015 | Author: | No comments yet »
Toyota Mark II sedan IV

Toyota tercel,canry timing

How do you take the ignition switch out of a Toyota tercel?

Ignition

REMOVAL INSTALLATION

Toyota 1984 — 1994 Guide

REMOVAL INSTALLATION

See 1

CAUTION

On models equipped a Supplemental Restraint System or air bag,» work must NOT be until at least 90 seconds passed from the time both the ignition switch is to the LOCK position and the negative is disconnected from the battery.

1. the negative battery cable.

2. Remove the screws which the steering column upper and covers.

3. Turn the ignition key to the ACC

4. Push the lock cylinder in with a small punch or

www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapter.

On some vehicles, it may be to remove the steering wheel and switch first.

To install:

Fig. 1: Depressing the lock stop tab

5. Withdraw the lock from the housing while the stop tab.

6. Remove the switch retaining screws, withdraw the switch from the housing.

7. Align the locking cam with the in the ignition switch, then the switch into the lock 8. Secure the switch with its

9. Make sure both the cylinder and the column lock are in the ACC Slide the cylinder into the housing until the stop tab the hole in the lock.

10. Install the column covers.

11. Engage the switch connector.

12. Check the switch operation in all positions.

to Top

www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapter.

www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapter.

How do you put front on a 1997 Toyota tercel?

From Chilton Manuel for cars 93-97:Toyota Tercel Toyota Paseo

1. Disconnect the battery cable to the battery. On equipped with an air bag, at least 90 seconds before


2.Raise support the vehicle.

3. the left engine undercover the transaxle.

4. If equipped with ABS disconnect the ABS speed sensor by bolt.

Toyota Mark II sedan IV

5. Remove the cotter pin and cap from the halfshaft.

6. Apply the brake and remove the hub

7.Disconnect the tie rod from the steering

8. Disconnect the lower ball from the lower control arm by bolt two nuts.

9. Using a hammer, disconnect the halfshaft the axle hub.

(sounds but is not. -that is either 9 or 10)

10. a brass bar and hammer, tap the inner out of the transaxle and remove the halfshaft.

TO

11.Using a new snapring, push the into the transaxle until it into position. Pull on the joint to make sure it is installed.

12.Push the out joint into the hub.

13. Connect the lower joint to the lower arm and torque the and two nuts to 59 ft lbs (80Nm).

14. Connect the tie rod to the and torque the nut to 36 ft. lbs.(49Nm). If the cotter pin be installed, tighten to the next

Do not loosen the nut.

15. Install the hub nut and to 152 ft.lbs. (206Nm). Install a new pin.

16. Refill the transaxle. the undercover and the wheel.

17.Check the front wheel

18.Connect the negative batter to the battery.

Toyota Mark II sedan IV

Interesting Articles

Here you can write a commentary on the recording "Toyota Tercel — Answers.com".

Sign in, to write a review.

Twitter-news
Our partners
Follow us
Contact us
Our contacts

dima911@gmail.com

Born in the USSR

423360519

About this site

For all questions about advertising, please contact listed on the site.


Toyota cars catalog with specifications, pictures, ratings, reviews and discusssions about cars Toyota.