CrewMax storage resolution — Undercover Swing Case Install | Toyota Tundra Forum

27 Апр 2015 | Author: | No comments yet »
Toyota i-swing

CrewMax storage resolution Undercover Swing Case

Mx SuperFly 25 [OP] Adrenaline

Joined: Jan 6, 2014 Member: #8 245 Gender: Male Location:

I am pretty sure everyone is with the rear seat Toyota made with the Crew Max. Coming a Double Cab Tacoma I was fairly that my new bigger truck be able to hold and carry more than ever. the rear seat passengers do a ton of room, I don#039;t have to store my jumper cables, tow tow hooks, flares, and whatever random items I was able to under AND behind the seats of my

The best solution I have is the Undercover Swing Case or SC-400P. I know it isn#039;t a 100% because I can#039;t the items in the cab of the truck. Now they are to the outside temps, and I lost a amount of bed space. I will say that the Tundra has enough bed for me, and the great design of the Swing keeps it out of the way, and it takes to remove/install.

The installation of the swing was cake, but I took a few pictures the install so I figured I would do a on it, just to show anyone who is about install how easy it is . I did run into one surprise, I had to remove the hook in the back and the bed wasn#039;t under the cargo hook, so I had to put two coats of rattle can on the bare Also, I didn#039;t have a T40, so I had to run out to get one.

DISCLAIMER: I know this is sense, but I don#039;t work for These are the steps I took, but you follow the directions and take safety precautions.

Tools

-Torx T40 — To remove cargo hook

-11mm — To secure the bracket to the bed


-Various drill bits to holes in the bed for the bracket bolts. I with a small hole and my way up to a hole just smaller the bolt, which is sort of tapping.

Supplies needed:

choice of primer/paint if you don#039;t to leave the bare metal of the bed I used Krylon Fusion, Satin. You won#039;t see it unless you the bracket and don#039;t replace the hook.

-Something or someone to the bracket in place, I used masking tape.

-Newspaper or something to prevent

-Blue masking tape to off around bare metal

Step 1: Remove rear hook of whatever side you are the swing case. Torx T40

Toyota i-swing

2: Tape off and put some type of protection (newspaper, etc.) the bare metal spots the hook was to paint it.

Step 3: bare spots.

Step 4: tape/overspray protection.

Step 5: the bracket in the rear corner in the picture, with it as flush to the and bed as possible.

Step 6: Hold the steady with something, your holes, and thread in the six bolts in the six holes in the bracket. I tighten them very especially the lower bolt on the arm the wheel well. There is a gap, they probably have included some of spacer. I plan to find to put in the gap when I have the time.

Step 7: Put the swing case on the pull the lever, and slowly it to latch. Mine closed/opened right out of the box, but if you have to adjustments you can make them on the

Inside without the removable

Inside aluminum reinforcement for

Inside with removable in..

Step 8: Clean the metal out of your bed from drilling.

Toyota i-swing
Toyota i-swing
Toyota i-swing
Toyota i-swing

Articles

Tagged as:

Here you can write a commentary on the recording "CrewMax storage resolution — Undercover Swing Case Install | Toyota Tundra Forum".

Sign in, to write a review.

Twitter-news
Our partners
Follow us
Contact us
Our contacts

dima911@gmail.com

Born in the USSR

423360519

About this site

For all questions about advertising, please contact listed on the site.


Toyota cars catalog with specifications, pictures, ratings, reviews and discusssions about cars Toyota.