Toyota 2WD/4WD IFS Front Ball Joint Spacers for Pickup, 4Runner and T100

12 Фев 2015 | Author: | No comments yet »


Toyota Hilux/4runner (4wd)

Toyota IFS Ball Joint

Standard 1-1/2 height, heights available

Description:

4WD Joint Spacer Installed

2WD Joint Spacer Kit

These are 1.5/38mm tall and provide that much front lift over stock settings as well as that more overall front travel. Actual front height will depend the vehicle’s weight distribution and torsion bar condition and adjustment may be 1.5 more or less than the height. Whether or not you prefer compression travel for high trips through desert or a balance between compression and travel more suited for trails, these spacers increase your functionality and to custom tailor your characteristics while increasing between the fenders and front If 1.5 is too tall for your needs, spacers are available on special An installed 4WD spacer is shown on the far hand image, above.

Also available for the 2WD Toyota as shown in the lower right image above. In the 2WD suspension, the bar is mounted to the lower control not the upper control arm like in the 4WD So the 2WD spacers will typically some torsion bar adjustment to a similar lift to the 4WD spacers. But the that the spacers provide just cranking up the torsion is that they provide the bump stop clearance so with the torsion bars set you still get full suspension

When combined with a rear suspension lift, a lift shackle or block or spring spacer. and possibly a body lift. it is easy and inexpensive to fit 33 tires under an IFS While a full 4 — 6 IFS lift can be installed and will fine for 33 tires, for less 1/2 the price and less than the time and effort, you can install a lift that will work better than the lift. In fitting with the Offroad motto of lift as as you need, but as little as possible . why use a 4 6 lift when 1.5-2.5 work just as well, if not With less lift, center of gravity will be drive line angles be less, brake lines usually not need to be extended, and there will be less on the components.

So apparently the saying Imitation is the form of flattery applies as well! In fact we have that some of the online sellers of Toyota Ball Spacer kits are selling exact duplicates of our product and we know now that they one of our kits and copied it. We say almost duplicates because they one minor, but crucial aspect of the our in their copy. We mention difference in the installation instructions, but in to not make it easy for the competition to that aspect of the design, not describe it here. But it sure it easy to offer low prices your RD budget is negligible as in you steal all your new designs. Oh, and to top it they even our plagiarized our instructions, nearly verbatim, down to the punctuation. If these were writing these for a college paper, their would likely fail for cheating. Not only that, but as we below, these vendors are 2.5 or 3 lift spacers, and yet, you measure their spacers, are only 1.5 tall. As Clara was so fond of saying, Where’s the And not only are the spacers not the full height, but we have found the cast aluminum spacers are lighter than the billet used in our spacers. Our CNC machined aluminum spacers weigh in at 16 oz. g.) each and a popular cast spacer off of eBay weighs 14.1 oz. (400 g). So

either those spacers are of some super light or they have voids in Since 6061 aluminum is the most common and lowest aluminum alloy and to get lighter you to add something like magnesium is twice the cost of aluminum, it is that these low cost spacers are made of some super light alloy, so in all they are a porous casting, air costs nothing and adds no Judging by the rough surface of those cast spacers. it is not to believe they are full of in the linked image, the cast is on the left next to our CNC billet on the right. Also, we have reports of purchasers of such also finding issues substandard grade hardware. In we have supplied our replacement for folks who
have experienced failure these cast spacer

NOTE: These spacers NOT fit Toyota Tacoma or Tundra nor will they fit 3rd or 4th generation or FJ Cruisers.

Toyota Hilux/4runner (4wd)
Toyota Hilux/4runner (4wd)
Toyota Hilux/4runner (4wd)

Interesting Articles

Here you can write a commentary on the recording "Toyota 2WD/4WD IFS Front Ball Joint Spacers for Pickup, 4Runner and T100".

Sign in, to write a review.

Twitter-news
Our partners
Follow us
Contact us
Our contacts

dima911@gmail.com

Born in the USSR

423360519

About this site

For all questions about advertising, please contact listed on the site.


Toyota cars catalog with specifications, pictures, ratings, reviews and discusssions about cars Toyota.